Ford D1PZ-14300-D Battery To Starter Motor Cable

Periodically inspect the entire length of each battery cable for damage, cracked or burned insulation and corrosion. Poor battery cable connections can cause starting problems and decreased engine performance. Check the cable-to-terminal connections at the ends of the cables for cracks, loose wire strands and corrosion. The presence of white, fluffy deposits under the insulation at the cable terminal connection is a sign that the cable is corroded and should be replaced. Check the terminals for distortion, missing mounting bolts and corrosion. When replacing the cables, always disconnect the negative cable first and hook it up last or the battery may be shorted by the tool used to loosen the cable clamps. Even if only the positive cable is being replaced, be sure to disconnect the negative cable from the battery first. Disconnect and remove the cable. Make sure the replacement cable is the same length and diameter. Clean the threads of the relay or ground connection with a wire brush to remove rust and corrosion. Apply a light coat of petroleum jelly to the threads to prevent future corrosion. Attach the cable to the relay or ground connection and tighten the mounting nut/bolt securely. Before connecting the new cable to the battery, make sure that it reaches the battery post without having to be stretched. Clean the battery posts thoroughly and apply a light coat of petroleum jelly to prevent corrosion. Connect the positive cable first, followed by the negative cable.

When replacing the cables, always disconnect the negative cable first and hook it up last to prevent shorting the battery.

Before disconnecting the battery cable(s), turn the ignition to the OFF position to prevent a draw on the battery, which could cause arcing and damage components like the alternator diodes.

The cable-to-terminal connections at the ends of the cables should be checked for cracks, loose wire strands, and corrosion.

The terminals should be checked for distortion, missing mounting bolts, and corrosion.

Before connecting the new cable to the battery, make sure that it reaches the battery post without having to be stretched.

Apply a light coat of petroleum jelly to the relay or ground connection to prevent future corrosion.

When replacing the cables, always disconnect the negative cable first and hook it up last to avoid shorting the battery.

Connect the positive cable first, followed by the negative cable.