To change the regulator, drop the tailgate and then remove access panel, water shield, and panel support. If the glass is stuck and the tailgate will not go down, remove the access panel and press the safety lockout on the bottom centre of the tailgate. To raise the glass, either use a jumper wire to connect to the motor or manually close the latches and operate the switch. If this doesn't work, first remove the glass. You can take the regulator and its screws and washers out by unscrewing it. For models with electric motor disconnect the wiring harness and remove the motor from tailgate. Clamp or lock the gear sectors together to prevent injury from tensioned counterbalance spring. To remove the glass, the tailgate must be lowered and the access panel, water shield and panel support are removed. With the latches closed manually and glass raised, the nuts that hold the glass and bracket to the window regulator can be accessed. If the glass will not raise, drill 5/8 inch access holes above the retaining nuts using a template, and provide a cover with glass before drilling. Take off the nuts holding the glass bracket to the window regulator, grind away the heads of the rivets which hold the glass to the glass bracket, and use a punch to remove the rivets, retainer and spacers. Detach the terminals for the rear-window defogger if fitted, take out the corner seals and inside weatherstrip, and slide the glass out the tailgate. Before reassemble, clean any metal swarf and touch up paint all surfaces of the holes. After installation give the window several up and down cycles to confirm all is working well.