To remove the window glass, first perform operating sequence to clear the indication and if the vehicle has side impact airbags, then remove the plastic cover for the side airbag. After that, release and unbolt the mounting bolts on the regulator or the electric motor, alongside with the detaching of the wiring multi-plug from the motor of the window regulator. Disconnect the cables of the regulator and, with a certain amount of delicacy, pull the window regulator towards the down position and out of the hole in the inner door panel. The same procedures apply for the rear window: therefore remove the glass and if there is a possibility, the plastic for side air bags. Remove mounting bolts of the regulator and manual winder and for the electric windows, disconnect the wiring multi-plugs from the window regulator motor. Last, using the same way through the hole in the inner door panel, take out the window regulator mechanism out of the door. The removal process is just the exact opposite of the installation process described above.