Ford E7TZ-11654-B Switch Assembly

It is necessary to pull the knob to release the Headlamp. You need to disconnect the ground cable of the battery. Pulling the knob to the position of the Headlamp. The shaft release button should be depressed and then, remove the assembly consisting of knob and shaft. Remove the finished panel from the instrument panel. When you unscrew the mounting nut, you can take off the switch, but don't forget about wiring the connector first. Plug in a plug from a wire into an instrument board switch for Headlamps, install it in an instrument board, and turn a nut on. Don't forget to hang the installed panel assembly on an instrument panel again. Push the shaft into switches with headlamp knobs until they catch. Connect your battery earth and check your light switch.