Ford COLY-14526-B Circuit Breaker Assembly

To replace a fuse, first turn the ignition switch OFF. Grasp the push-in type fuse with the provided tool, or a pair of needle-nose pliers. Look through the side of the fuse body to determine if the fuse element is blown. Check the amperage rating of the fuse which was removed and obtain a new fuse of the same rating. Align the fuse with its mounting position and push it into place until fully seated in the panel. Turn the ignition switch on and operate the accessory that was protected by that fuse.

On 1991 and earlier models, the fuse block is located below the left side of the dash, under a cover that is secured with two screws.

Pry open the plastic cover at the left end of the instrument panel (access with the driver's door open).

Be sure to replace blown fuses with the correct type. Fuses of different ratings are physically interchangeable, but only fuses of the proper rating should be used.

Twisting could force the terminals open too far, resulting in a bad connection.

Yes, fuses of different ratings are physically interchangeable, but replacing a fuse with one of a higher or lower value than specified is not recommended.

A blown fuse can be confirmed visually by inspecting it.

When replacing blown fuses, it is important to replace them with the correct type. Fuses of different ratings are physically interchangeable, but only fuses of the proper rating should be used.

Miniaturized fuses with a blade terminal design are used in the fuse block in the passenger compartment.

If the replacement fuse immediately fails, it is recommended not to replace it again until the cause of the problem is isolated and corrected. In most cases, the cause will be a short circuit in the wiring caused by a broken or deteriorated wire.

Always disconnect the cable to the negative battery terminal before replacing high current fuses.

The electrical circuits of the vehicle are protected by a combination of fuses, circuit breakers, and fusible links.

Two types of fuses are used, depending on the date of manufacture. Early models use a glass tube design, while later models use miniaturized fuses with a blade terminal design.

If the replacement fuse immediately fails, don't replace it again until the cause of the problem is isolated and corrected. In most cases, the cause will be a short circuit in the wiring caused by a broken or deteriorated wire.