Genuine Ford Bronco Brake Caliper
CaliperEnter your vehicle info to find more parts and verify fitment
- Select Vehicle by VIN
- Select Vehicle by Model
Select by VIN
orEnter your VIN for the most accurate results.Enter your VIN for the most accurate results.
Select by Model
-- Select Make --
-- Select Model --
-- Select Year --
8 Brake Calipers found
Ford Bronco Brake Caliper Assembly-Less Pads
Part Number: F4TZ-2V120-BRM- Other Name: Caliper Assy - Brake - Less Pads
- Position: Passenger Side
- Replaced by: GU2Z-2V120-TRM
Ford Bronco Caliper With Pads
Part Number: F4TZ-2V130-BRM- Position: Passenger Side
- Replaced by: GU2Z-2V120-TRM
Ford Bronco Brake Caliper Assembly-Less Pads
Part Number: F2TZ-2V120-ARM- Other Name: Caliper Assy - Brake - Less Pads; Caliper, Caliper Assembly
- Manufacturer Note: RH, 4x2
- Position: Passenger Side
- Replaces: F2TZ-2B120-A
Ford Bronco Caliper With Pads
Part Number: F4TZ-2V131-BRM- Position: Driver Side
- Replaced by: GU2Z-2V121-TRM
Ford Bronco Brake Caliper Assembly-Less Pads
Part Number: F2TZ-2V121-ARM- Other Name: Caliper Assy - Brake - Less Pads; Caliper, Caliper Assembly
- Manufacturer Note: LH, 4x2
- Position: Driver Side
- Replaces: F2TZ-2B121-A
Ford Bronco Caliper With Pads
Part Number: F2TZ-2V130-ARM- Manufacturer Note: RH, 4x2
- Position: Passenger Side
Ford Bronco Caliper With Pads
Part Number: F2TZ-2V131-ARM- Manufacturer Note: LH, 4x2
- Position: Driver Side
Ford Bronco Brake Caliper Assembly-Less Pads
Part Number: F4TZ-2V121-BRM- Other Name: Caliper Assy - Brake - Less Pads
- Position: Driver Side
- Replaced by: GU2Z-2V121-TRM
Ford Bronco Brake Caliper Parts Questions & Answers
- Q: How to rebuild calipers?A: Before starting an overhaul, consider all options including new and rebuilt calipers. If rebuilding, always do it in pairs and ensure a kit is available. A leaking caliper seal can be identified by a drop in the master cylinder level or brake fluid on the wheel. To rebuild, remove the calipers and Brake Pads, disconnect the caliper from the hose, and clean it. Use compressed air to remove the piston, then remove the dust boot and piston seal. Clean all parts and inspect for damage. If damaged, replace the caliper assembly. To reassemble, lubricate a new piston seal and install it, along with a new dust boot. Insert the piston into the bore, then reinstall the caliper and pads, bleed the brakes, and reinstall the wheel(s) and check the brakes before operating.
