Lincoln F6TZ-7A098-BB Filter Assembly

Perform transmission fluid replacement after engine has cooled. Get recommended fluid, new drain plug, new filter, and new gasket if needed. Use jackstands, drain pan, newspapers, and rags. Elevate vehicle, place drain pan, remove drain plug or pan bolts, drain fluid. Clean gasket surface, clean pan, replace filter. Install new seal, filter, and gasket. Attach pan, tighten bolts. Remove torque converter cover, drain fluid, install new plug, lower vehicle. Add 6-1/2 quarts of fluid, start engine, shift gears, check fluid level. Check for leaks, add fluid if needed.

Once the vehicle is securely supported on jackstands, place the drain pan under the transmission oil pan and remove the pan bolts.

Check under the vehicle for any signs of leaks during the first few trips to ensure that the transmission fluid replacement was successful.

After reinstalling the transmission oil pan, lower the vehicle and gradually add transmission fluid through the dipstick tube.

Clean the gasket surface of the transmission to remove all remnants of the old gasket and sealant. Drain the fluid from the transmission pan, clean it with solvent, and thoroughly dry it. Upon initial service, you may find a plastic plug in the bottom of the pan, which was used to keep contamination out during assembly. Discard this plug. Remove the old filter from the transmission. If the filter seal didn't come out with the filter, remove it carefully without damaging the seal bore. Install a new seal and filter.

NO, PART SOLD SEPARATQ