Ford 5L8Z-3A329-FA Shaft

To install the intermediate shaft, follow these steps. Lubricate the lips of the transaxle seal with multipurpose grease. Carefully guide the intermediate shaft into the transaxle side gear and then install the mounting nuts for the bearing support and tighten them. The remainder of the installation is the reverse of removal.

To remove the intermediate shaft, follow these steps. Remove the right side wheel cover or hub cap and break the hub nut loose with a socket and large breaker bar. Loosen the wheel lug nuts and raise the vehicle on jackstands. Remove the wheel and the driveaxle/hub nut from the axle. Swing the knuckle/hub assembly out until the end of the driveaxle is free of the hub. If the driveaxle splines stick in the hub, tap on the end of the driveaxle with a plastic hammer. Support the outer end of the driveaxle with a piece of wire to avoid unnecessary strain on the inner CV joint. Remove the driveaxle. Remove the bearing support nuts and slide the intermediate shaft out of the transaxle. Be careful not to damage the differential seal when pulling the shaft out. Check the support bearing for smooth operation by turning the shaft while holding the bearing. If there is any roughness, have a new bearing installed at an automotive machine shop or qualified repair facility.