Ford E6UZ-4234-B Rear Axle Shaft Assembly

Failure to correctly install the axleshaft C-locks or lockpin can result in loss of wheel/axle assembly or rear wheel lockup.

It is rare to find individual axle components for local repair work because dismantling and rebuilding this unit is generally recognized as an in-plant job requiring special equipment and techniques.

The Dana model 60 Monobeam axle is now standard on the F350 4x4.

Remove the brake calipers and secure them on the frame in a manner that prevents suspending the caliper from the hose to avoid damage to the tube portion of the caliper hose assembly.

10. Inspect the seals on the outer axle shaft ends, and replace them if necessary. Replace the seals as follows: a. Remove the old seal from the axle shaft by driving them off with a hammer. b. Thoroughly clean the axle seal area of the shaft. c. Place the shaft in a press and install the new seal using the Spindle/Axle Seal Installer Tool T83T-3132-A, or equivalent.

Add 2 oz. of friction modifier or equivalent.

The rear axle code may be found in two places on the vehicle.

Carefully lower the axle assembly and remove it from under the vehicle.

If a loss of fluid is observed, check the differential lubricant level and refill if required.

Disconnect the lower end of the shock absorbers from the axle housing and disconnect the rear stabilizer bar if so equipped.