Ford 7C1Z-12A648-A Sender Assembly

You can Select Your Vehicle to check if 7C1Z-12A648-A fits your vehicle.

The ECT sensor is not to be reused. Install only a NEW ECT sensor once it is removed. The ECT sensor is used on all 1.5L and 1.6L four-cylinder models, 2006 through 2009 3.0L V6 models, and 2.7L V6 models. To remove the ECT sensor on 1.5L and 1.6L models, lift the engine cover and remove the expansion tank and air filter housing outlet duct. Locate the ECT sensor on the thermostat housing, disconnect the electrical connector, remove the retaining clip, and pull out the sensor. For 2006 through 2009 3.0L V6 models, disconnect the electrical connector, pull out the locking tab, rotate the sensor counterclockwise, and remove it from the coolant passage. Inspect the sensor O-ring and replace if necessary. To install, insert the new ECT sensor into the coolant passage and turn it clockwise until the locking tab snaps into place. For 2.7L V6 models, remove the intake manifold, disconnect the electrical connector, unscrew the ECT sensor, and discard it. Install the new ECT sensor and tighten it. Refill the cooling system.