Ford D3AZ-9155-C Fuel Filter Assembly

Fuel filters are paper replacement type and can be found screwing into carburetor fuel inlet or in fuel line. Ensure engine is cold, sat for at least 3 hours. Collect necessary tools, including appropriate replacement filter, wrenches for flare nut fittings on carburetor-mounted filters, or screwdriver and pliers for in-line types. Have clean rags ready to catch spilled fuel. Remove air cleaner assembly, note positions of vacuum hoses if disconnected. Follow fuel hose from fuel pump to locate filter. For carburetor-mounted filters, use wrench to hold nut, loosen fitting, and disconnect fuel line. Move line for better access, unscrew fuel inlet filter nut, and replace filter, gasket, and spring. Hand-tighten fuel inlet fitting into carburetor, then fully tighten using two wrenches. For screw-in type carburetor filters, remove clamps, hose, and filter, then hand-start new filter and fully tighten. Cut new fuel hose, position spring clamps, and attach to filter and steel fuel supply line. For in-line filters, remove clamps and hoses, cut new hoses, install clamps, and attach to filter, metal supply line, and carburetor inlet fitting. After installation, run engine, check for leaks, and reinstall air cleaner assembly, reconnecting hoses to original positions.

To replace the filter on a Motorcraft - 2700 VV carburetor, remove the air cleaner and discard the filter hose clips. Unscrew and discard the old filter. Install the new filter, ensuring the directional arrow points toward the carburetor. When turning on the engine, look for fuel leaks.

To replace the filter on a Motorcraft - 2700 VV carburetor, remove the air cleaner and discard the filter hose clips. Unscrew and discard the old filter. Install the new filter, ensuring the directional arrow points toward the carburetor. When turning on the engine, look for fuel leaks.

First, remove the air cleaner of the carburetor. Loosen the clips on the fuel line at the filter, pull off the lines of petrol and put away the clips. On later models, unscrew the filter from the carburetor as shown. Fit a new filter with new clips and check for fuel leaks after starting the engine. Ensure while installing the replacement filter that it is positioned in correct direction if it has an arrow indicating flow of fuel. Reinstall the air cleaner.

Find the current filter that is on the frame rail near the fuel tank, and buy a new fuel filter for fuel injected models. You should clean hose fittings, pull out hairpin clips, and separate fuel hoses from the filter. Before removing the old filter from its bracket, observe which way the arrow points on it, and loosen clamps or bolts that hold it in place. Attach the new filter to the bracket and put it in place without changing anything else before connecting the hose with hairpin clips. Start your engine and look for any leaking gasoline. To begin with, on carbureted models you need to remove air cleaner housing. Underneath it, you will have to place a rag then disconnect the fuel line(s) from filter. Use clamps to secure an inline filter properly. For carburetor mounted filters, if you find it necessary, remove either old filters or fuel inlet fitting(It could be one of these two), apply thread sealant where necessary then screw tightly ensuring a new filter is correctly installed.

After removing the filter, drain it and discard it in a non-incendiary refuse container. Replace the filter with an exact duplicate replacement and push it into new rubber connecting hoses. Tighten all clamps, start the vehicle, and check for leaks.

The fuel filter is located on the inside of the left-side frame rail.