Ford YL8Z-4L537-EA Boot

During reassembly, a new sealing boot clamp and boot are slid onto the axleshaft, with care taken to wrap the splines with tape to prevent boot damage. A new bearing retainer clip is placed onto the axle shaft, and grease from the sealing boot kit is applied to the outer CV joint assembly housing and inside the boot. The splines on the axleshaft are aligned with the splines on the outer CV joint assembly, and the CV joint is gently driven onto the axleshaft with a soft-faced hammer. Pressure in the boot is equalized, boot clamps are tightened, and the driveaxle is installed.