How to remove and install Windshield Wiper Arms on Ford Ranger?

For models from 2010 and earlier, to prevent damage to the windshield and ensure normal wiper operation, keep the windshield wet during the initial step. Begin by turning the Windshield Wiper Switch On, allowing the wipers to cycle several times before turning it Off, which positions the Windshield Wiper Arm parallel to the base of the windshield. Lift the Windshield Wiper Arm and blade assembly away from the windshield, pull out the small latch near the spindle, and lower the arm to rest on the latch, keeping the blade several inches away from the windshield. Wiggle the arm back-and-forth to remove it from the spindle. For installation, position the arm back onto the post in the parked position, ensuring it is not too low to avoid hitting the base of the windshield during operation, and confirm that the latch is seated correctly in the groove of the wiper spindle. For 2011 models, pull up on each wiper pivot arm, remove the retaining tab, and take off the arms. Next, remove the PCM mounting fasteners and set the PCM and harness aside, followed by removing the right Windshield Wiper Arm access cover screws and the cover itself. Then, take out the Power Distribution Box mounting fasteners and set the PDB aside, followed by the left Windshield Wiper Arm access cover screws and the cover. Reach through the access opening to unsnap the Windshield Wiper Motor clip from the mounting bracket and pivot shaft, then remove the right and left Windshield Wiper Arms from the pivot shafts and disconnect them from the Windshield Wiper Motor. Remove the pivot nuts from each side, and through the right access opening, take out the left and right mounting brackets and pivot shafts. For installation, reverse the removal steps, starting with the left Windshield Wiper Arm followed by the right arm, ensuring the Windshield Wiper Motor clip is fully seated on the pivot shaft to prevent damage, and tighten the fasteners securely.

Genuine Ford Ranger Windshield Wiper Arm

Wiper Arm

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

10 Windshield Wiper Arms found

View related parts
Ford Ranger Wiper Arm
Part Number: KB3Z-17526-A
$36.02 MSRP: $52.67
You Save: $16.65 (32%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Arm Assembly - Wiper; Wiper Arm
- Position: Passenger Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2019-2023 Ford Ranger | 4 Cyl 2.3 L GAS, 4 Cyl 2.3L TIVCT DI TC | 10-Speed Automatic Transmission (10R80), 2 Whl L/H Rear Drive-High Ride, Four-Wheel Drive (Part Time) (Left Hand Drive), Left Hand Drive
View related parts
Ford Ranger Wiper Arm
Part Number: 6L5Z-17526-A
$32.06 MSRP: $45.67
You Save: $13.61 (30%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Arm Assembly - Wiper; Wiper Arm
- Replaces: 4L5Z-17526-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2004-2011 Ford Ranger | 4 Cyl 2.3L NA Petrol, 6 Cyl 3.0L OHV EFI, 6 Cyl 4.0L SOHC EFI | 5-Speed Automatic Transmission - 5R44E/5R55E, 5-Speed Manual Transmission - R1HD, 5-Speed Manual Transmission M5R1, Four-Wheel Drive (Part Time) (Left Hand Drive), Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Ranger Wiper Arm
Part Number: KB3Z-17527-A
$36.89 MSRP: $53.00
You Save: $16.11 (31%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Arm Assembly - Wiper; Wiper Arm
- Position: Driver Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2019-2023 Ford Ranger | 4 Cyl 2.3 L GAS, 4 Cyl 2.3L TIVCT DI TC | 10-Speed Automatic Transmission (10R80), 2 Whl L/H Rear Drive-High Ride, Four-Wheel Drive (Part Time) (Left Hand Drive), Left Hand Drive
View related parts
Ford Ranger Wiper Arm Assembly
Part Number: 4L5Z-17526-AA
$32.06 MSRP: $45.67
You Save: $13.61 (30%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Arm Assembly - Wiper
- Replaced by: 6L5Z-17526-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2004-2006 Ford Ranger | 4 Cyl 2.3L NA Petrol, 6 Cyl 3.0L OHV EFI, 6 Cyl 4.0L SOHC EFI | 5-Speed Automatic Transmission - 5R44E/5R55E, 5-Speed Manual Transmission - R1HD, 5-Speed Manual Transmission M5R1, Four-Wheel Drive (Part Time) (Left Hand Drive), Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Ranger Wiper Linkage
Part Number: N1WZ-17566-A
$53.59 MSRP: $77.00
You Save: $23.41 (31%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Arm And Pivot Shaft Assembly; Wiper Arm, Wiper Linkage, Wiper Transmission
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2024-2025 Ford Ranger | 4 Cyl 2.3 L GAS, 6 Cyl 2.7 L GAS, 6 Cyl 3.0 L GAS
View related parts
Ford Ranger Wiper Arm Assembly
Part Number: F77Z-17526-BA
$39.28 MSRP: $56.43
You Save: $17.15 (31%)
Product Specifications
- Other Name: Arm Assembly - Wiper
- Position: Passenger Side And Driver Side
- Replaced by: 1L2Z-17526-DA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1997-2000 Ford Ranger | 4 Cyl 2.3L, 4 Cyl 2.5L, 6 Cyl 3.0L, 6 Cyl 4.0L | 4AT 4R44E, 5AT 5R55E, 5MT
View related parts
Ford Ranger Wiper Arm Assembly
Part Number: F67Z-17526-AB
Product Specifications
- Other Name: Arm Assembly - Wiper; Wiper Arm
- Position: Passenger Side And Driver Side
- Replaces: F57Z-17526-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1995-1997 Ford Ranger | 4 Cyl 2.3L, 6 Cyl 3.0L, 6 Cyl 4.0L | 4AT 4R44E, 4AT 4R55E, 4AT A4LD, 5AT 5R55E, 5MT
View related parts
Ford Ranger Wiper Arm
Part Number: F3TZ-17526-A
Product Specifications
- Other Name: Arm Assembly - Wiper; Wiper Arm
- Position: Passenger Side And Driver Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1993-1994 Ford Ranger | 4 Cyl 2.3L, 6 Cyl 3.0L, 6 Cyl 4.0L | 4AT A4LD, 5MT
View related parts
Ford Ranger Wiper Arm Assembly
Part Number: F1TZ-17526-A
Product Specifications
- Other Name: Arm Assembly - Wiper
- Position: Passenger Side And Driver Side
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1991-1992 Ford Ranger | 4 Cyl 2.3L, 6 Cyl 2.9L, 6 Cyl 3.0L, 6 Cyl 4.0L | 4AT A4LD, 5MT
View related parts
Ford Ranger Wiper Arm Assembly
Part Number: F57Z-17526-A
Product Specifications
- Other Name: Arm Assembly - Wiper
- Position: Passenger Side And Driver Side
- Replaced by: F67Z-17526-AB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1995 Ford Ranger | 4 Cyl 2.3L, 6 Cyl 3.0L, 6 Cyl 4.0L | 4AT 4R44E, 4AT 4R55E, 4AT A4LD, 5MT

Ford Ranger Windshield Wiper Arm

We provide a wide range of Ford Ranger Windshield Wiper Arm at the optimal prices. If you need Ford Ranger Windshield Wiper Arm, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your doorstep with a fast delivery service.

Ford Ranger Windshield Wiper Arm Parts Questions & Experts Answers

Wiper Arm Assembly
F77Z-17526-BA
Q:
How to remove and install Windshield Wiper Arms on Ford Ranger?
Posted by Bang N.
A:
For models from 2010 and earlier, to prevent damage to the windshield and ensure normal wiper operation, keep the windshield wet during the initial step. Begin by turning the Windshield Wiper Switch On, allowing the wipers to cycle several times before turning it Off, which positions the Windshield Wiper Arm parallel to the base of the windshield. Lift the Windshield Wiper Arm and blade assembly away from the windshield, pull out the small latch near the spindle, and lower the arm to rest on the latch, keeping the blade several inches away from the windshield. Wiggle the arm back-and-forth to remove it from the spindle. For installation, position the arm back onto the post in the parked position, ensuring it is not too low to avoid hitting the base of the windshield during operation, and confirm that the latch is seated correctly in the groove of the wiper spindle. For 2011 models, pull up on each wiper pivot arm, remove the retaining tab, and take off the arms. Next, remove the PCM mounting fasteners and set the PCM and harness aside, followed by removing the right Windshield Wiper Arm access cover screws and the cover itself. Then, take out the Power Distribution Box mounting fasteners and set the PDB aside, followed by the left Windshield Wiper Arm access cover screws and the cover. Reach through the access opening to unsnap the Windshield Wiper Motor clip from the mounting bracket and pivot shaft, then remove the right and left Windshield Wiper Arms from the pivot shafts and disconnect them from the Windshield Wiper Motor. Remove the pivot nuts from each side, and through the right access opening, take out the left and right mounting brackets and pivot shafts. For installation, reverse the removal steps, starting with the left Windshield Wiper Arm followed by the right arm, ensuring the Windshield Wiper Motor clip is fully seated on the pivot shaft to prevent damage, and tighten the fasteners securely.
Answered by Ford Parts Specialist Bastien / Dec 01, 2023