How to remove and install the Throttle Cable on Ford Ranger?

First, for example, the assembly and fastening of the accelerator linkage shield, which is provided over the Throttle Cable linkage, must be loosened. This is done by unclipping the Throttle Cable from the throttle lever ball stud at the throttle body using a hairpin clip. Then, unbolt the cable from the bracket on the intake manifold, however, depending on the later models the position of the bracket may be different. Locating the accelerator pedal from inside the vehicle, unscrew the cables end that is fixed atop the accelerator pedal. Open the retaining clips at the dash panel and pass the cable through the dash panel to the engine area. To install it back reverse the order you used to remove it and be certain not to allow any wires or hoses to touch any part of the accelerator controls that is moving. This should be checked with the engine off and the accelerator pedal firmly pushed to the floor before starting the engine. After bringing the engine to life inspect the throttle operation and a similar operation when the accelerator pedal is released normalising the rpm.

Genuine Ford Ranger Throttle Cable

Choke Cable

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

13 Throttle Cables found

View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: 3L5Z-9A758-BA
$24.69 MSRP: $44.89
You Save: $20.20 (45%)
ADD TO CART
Product Specifications
- Other Name: Cable Assembly - Throttle Control
- Replaced by: 6L5Z-9A758-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2004-2011 Ford Ranger | 4 Cyl 2.3L NA Petrol | 5-Speed Automatic Transmission - 5R44E/5R55E, 5-Speed Manual Transmission - R1HD, 5-Speed Manual Transmission M5R1, Four-Wheel Drive (Part Time) (Left Hand Drive), Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: F1TZ-9A758-F
Product Specifications
- Other Name: Cable Assembly - Throttle Control; Throttle Cable
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1991-1994 Ford Ranger | 6 Cyl 4.0L | 4AT A4LD, 5MT
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: 4L5Z-9A758-AA
Product Specifications
- Other Name: Cable Assembly - Throttle Control; Throttle Cable
- Replaces: 2L5Z-9A758-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2002-2008 Ford Ranger | 6 Cyl 3.0L, 6 Cyl 3.0L OHV EFI | 5-Speed Automatic Transmission - 5R44E/5R55E, 5-Speed Manual Transmission - R1HD, 5-Speed Manual Transmission M5R1, 5AT 5R44E, 5AT 5R55E, 5MT, Four-Wheel Drive (Part Time) (Left Hand Drive), Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: F87Z-9A758-BD
Product Specifications
- Other Name: Cable Assembly - Throttle Control; Cable Assembly, Throttle Cable
- Replaces: 1L5Z-9A758-DA, F87Z-9A758-BC
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1998-2001 Ford Ranger | 6 Cyl 3.0L | 4AT 4R44E, 5AT 5R44E, 5AT 5R55E, 5MT
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: F87Z-9A758-BC
Product Specifications
- Other Name: Cable Assembly - Throttle Control
- Replaced by: F87Z-9A758-BD
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1998 Ford Ranger | 6 Cyl 3.0L | 4AT 4R44E, 5AT 5R55E, 5MT
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: F87Z-9A758-AA
Product Specifications
- Other Name: Cable Assembly - Throttle Control; Cable Assembly, Throttle Cable
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1998-2001 Ford Ranger | 4 Cyl 2.5L | 4AT 4R44E, 5AT 5R44E, 5AT 5R55E, 5MT
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: 2L5Z-9A758-CA
Product Specifications
- Other Name: Cable Assembly - Throttle Control; Cable Assembly, Throttle Cable
- Replaces: 1L2Z-9A758-GA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2004-2011 Ford Ranger | 6 Cyl 4.0L SOHC EFI | 5-Speed Automatic Transmission - 5R44E/5R55E, 5-Speed Manual Transmission - R1HD, 5-Speed Manual Transmission M5R1, Four-Wheel Drive (Part Time) (Left Hand Drive), Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
- 2001 Ford Ranger | 6 Cyl 4.0L | 4AT 4R44E, 5AT 5R44E, 5AT 5R55E, 5MT
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: 2L5Z-9A758-AA
Product Specifications
- Other Name: Cable Assy - Throttle Control
- Replaced by: 4L5Z-9A758-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2002-2003 Ford Ranger | 6 Cyl 3.0L | 5AT 5R44E, 5AT 5R55E, 5MT
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: F57Z-9A758-A
Product Specifications
- Other Name: Cable Assy - Throttle Control; Throttle Cable
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1995-1997 Ford Ranger | 4 Cyl 2.3L | 4AT 4R44E, 4AT 4R55E, 4AT A4LD, 5AT 5R55E, 5MT
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: F87Z-9A758-CA
Product Specifications
- Other Name: Cable Assembly - Throttle Control
- Manufacturer Note: OHV
- Replaced by: YL2Z-9A758-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1998-2000 Ford Ranger | 6 Cyl 4.0L | 4AT 4R44E, 5AT 5R55E, 5MT
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: F47Z-9A758-H
Product Specifications
- Other Name: Cable Assy - Throttle Control; Throttle Cable
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1994 Ford Ranger | 6 Cyl 3.0L | 4AT A4LD, 5MT
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: 1L5Z-9A758-DA
Product Specifications
- Other Name: Cable Assy - Throttle Control
- Replaced by: F87Z-9A758-BD
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2001 Ford Ranger | 6 Cyl 3.0L | 4AT 4R44E, 5AT 5R44E, 5AT 5R55E, 5MT
View related parts
Ford Ranger Throttle Control Cable Assembly
Part Number: 1L2Z-9A758-GA
Product Specifications
- Other Name: Cable Assembly - Throttle Control
- Replaced by: 2L5Z-9A758-CA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2001 Ford Ranger | 6 Cyl 4.0L | 4AT 4R44E, 5AT 5R44E, 5AT 5R55E, 5MT

Ford Ranger Throttle Cable

Across all Ford Ranger models the throttle cable stands as a vital part which demonstrates high reliability during engine performance. As the physical component between the pedal and throttle plate the Ford Ranger Throttle Cable allows for exact engine air intake control to boost operational effectiveness. Ford Rangers feature a braided metal cable for throttle control in previous designs but ETC now serves as the management system for electronic throttle regulation together with traction control systems and stability equipped models. The Ford Ranger's performance and safety commitment continues to develop as evidence of the vehicle's capability across various driving conditions. This throttle cable fits a variety of Ford Ranger models which allows drivers of all types to utilize it. By engineering the throttle system this way the vehicle becomes more secure through immediate throttle responsiveness. The Ford Ranger Throttle Cable stands out for its durable build which prevents breakdown and its effective operational longevity. Reliability has earned the the automaker model its market recognition through a component called the car Throttle Cable which simultaneously provides improved driving experiences and protected vehicle safety. The car Throttle Cable continues to play an essential role in the car range because it delivers both performance efficiency and security according to its proven record.

We provide a wide range of Ford Ranger Throttle Cable at the optimal prices. If you need Ford Ranger Throttle Cable, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your doorstep with a fast delivery service.

Ford Ranger Throttle Cable Parts Questions & Experts Answers

Throttle Control Cable Assembly
3L5Z-9A758-BA
Q:
How to remove and install the Throttle Cable on Ford Ranger?
Posted by Jenine D.
A:
First, for example, the assembly and fastening of the accelerator linkage shield, which is provided over the Throttle Cable linkage, must be loosened. This is done by unclipping the Throttle Cable from the throttle lever ball stud at the Throttle Body using a hairpin clip. Then, unbolt the cable from the bracket on the Intake Manifold, however, depending on the later models the position of the bracket may be different. Locating the accelerator pedal from inside the vehicle, unscrew the cables end that is fixed atop the accelerator pedal. Open the retaining clips at the dash panel and pass the cable through the dash panel to the engine area. To install it back reverse the order you used to remove it and be certain not to allow any wires or hoses to touch any part of the accelerator controls that is moving. This should be checked with the engine off and the accelerator pedal firmly pushed to the floor before starting the engine. After bringing the engine to life inspect the throttle operation and a similar operation when the accelerator pedal is released normalising the rpm.
Answered by Ford Parts Specialist John / Feb 06, 2025