For 2010 and earlier models, begin by carefully prying out the trim covers to access the console rear mounting bolts, then remove the bolts. Next, lift off the armrest and take out the single screw located beneath it. Proceed to remove the cup holder screws, lift off the cup holder, and take out the two screws underneath it. Lift the console away from the mounting brackets and detach it from the vehicle, with installation being the reverse of the removal steps. For 2011 models, if the console has a speaker housing, lift the mats from the storage tray and cup holder to remove the screws beneath them. Then, take out the pushpin fasteners and detach the front section of the console. Position the seats fully forward, remove the armrest bolt covers and bolts, and then remove the armrest. Next, remove the rear screw from the console and slide the seats all the way to the rear. If applicable, remove the cup holder, then take out the front screws and remove the console, tilting the rear of the housing up slightly if it has a speaker housing. Installation follows the reverse order of removal.