How do you replace the headlight switch on Ford Crown Victoria?

Relax the connection of the cable on the negative terminal of the battery. On 1989 and models before it, you will need to reach under the dash and press at the bottom of the switch where it can be found to release the knob and to allow the shaft to be removed from the switch. Take off the instrument cluster bezel and then, with the help of a 5/8-inch socket, turn the nut and get the switch down, disconnect the electrical connector and take it out. Insert the new switch into the position on the bracket and tightened the nut for holding the switch firmly. Put the knob and shaft into the switch and the rest of the process would be the opposite of the removal process. Pry the headlight switch knob counterclockwise by inserting a pointed instrument beneath the release tab at the base of the knob For the 1990-1995 models, you have to first remove the instrument cluster bezel. Screw and pull out the switch out of the instrument panel, and then unbolt the switch, disconnect its connector and then take the switch out of the car while the process of installation will be vice versa. For the 1996 to 2004 models-with the switch cavity exposed, turn the headlight knob counter clockwise until it can be separated from the bottom of the switch shaft, then remove the instrument cluster bezel, press on the connector release tab on the back of the switch to disconnect the electrical wiring connector, unscrew the switch retainer nut and pull the switch from the bracket and to install, reverse the above noted removal procedures. For the 2005 and later models the headlight switch assembly is clipped to the instrument panel and it required to use trim panel tool to pry it out, disconnect the electrical connectors, this process followed by disconnecting the assembly from the dash and reconnecting the electrical connectors and reinstalled the assembly.

Genuine Ford Crown Victoria Headlight Switch

Headlamp Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

17 Headlight Switches found

View related parts
Ford Crown Victoria Switch And Wire Assembly - Control
Part Number: 2W7Z-11654-AA
$57.12 MSRP: $78.05
You Save: $20.93 (27%)
ADD TO CART
Product Specifications
- Other Name: Switch And Wire Assy - Control
- Manufacturer Note: Switch to control wigwag module to flash headlamps, Police Interceptor
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2002-2003 Ford Crown Victoria | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Ford Crown Victoria Switch Assy - Headlamp Levelling
Part Number: 4W7Z-11654-AAB
Product Specifications
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2004-2007 Ford Crown Victoria | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI | 4AT, 4AT 4R70W, 4AT 4R75W, 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Switch Assembly - Headlamp Levelling
Part Number: 4W7Z-11654-BAA
Product Specifications
- Other Name: Switch Assy - Headlamp Levelling
- Manufacturer Note: Includes thumbwheel rheostat for panel/light dim, Police Interceptor
- Replaced by: 8W7Z-11654-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2004-2007 Ford Crown Victoria | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI | 4AT, 4AT 4R70W, 4AT 4R75W, 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Switch Assembly
Part Number: F2AZ-11654-B
Product Specifications
- Other Name: Switch Assy; Headlamp Switch
- Manufacturer Note: Push,pull switch , electronic instr. cluster, FROM 9/91 TO 11/94
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1992-1995 Ford Crown Victoria | 8 Cyl 4.6L | 4AT AOD, 4AT AOD-E
View related parts
Ford Crown Victoria Switch Assy - Headlamp Levelling
Part Number: 7W7Z-11654-BA
Product Specifications
- Replaced by: 8W7Z-11654-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2008 Ford Crown Victoria | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Switch Assy - Headlamp Levelling
Part Number: 8W7Z-11654-BA
Product Specifications
- Other Name: Headlamp Switch
- Replaces: 4W7Z-11654-BAA, 7W7Z-11654-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2004-2011 Ford Crown Victoria | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, 4AT, 4AT 4R70W, 4AT 4R75W, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Switch Assembly
Part Number: F1VY-11654-B
Product Specifications
- Other Name: Switch Assy; Headlamp Switch
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1992 Ford Crown Victoria | 8 Cyl 4.6L | 4AT AOD, 4AT AOD-E
View related parts
Ford Crown Victoria Switch Assembly
Part Number: F2AZ-11654-A
Product Specifications
- Other Name: Switch Assy; Headlamp Switch
- Manufacturer Note: Push-pull switch, mechanical instr. cluster, FROM 9/91 TO 11/94
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1992-1995 Ford Crown Victoria | 8 Cyl 4.6L | 4AT AOD, 4AT AOD-E
View related parts
Ford Crown Victoria Switch Assembly
Part Number: F7AZ-11654-BA
Product Specifications
- Other Name: Switch Assy
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1997 Ford Crown Victoria | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Ford Crown Victoria Switch Assembly
Part Number: F7AZ-11654-BB
Product Specifications
- Other Name: Switch Assy; Headlamp Switch
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1997 Ford Crown Victoria | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Ford Crown Victoria Switch Assembly
Part Number: F8AZ-11654-AA
Product Specifications
- Other Name: Switch Assy
- Manufacturer Note: Police Interceptor
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1998 Ford Crown Victoria | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Ford Crown Victoria Switch Assembly
Part Number: FOVY-11654-B
Product Specifications
- Other Name: Switch Assy; Headlamp Switch
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1992 Ford Crown Victoria | 8 Cyl 4.6L | 4AT AOD, 4AT AOD-E
View related parts
Ford Crown Victoria Switch Assembly
Part Number: XW7Z-11654-AA
Product Specifications
- Other Name: Switch Assy; Headlamp Switch
- Manufacturer Note: Headlamp & panel dimmer controls switch asy
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1999-2002 Ford Crown Victoria | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Ford Crown Victoria Switch Assembly
Part Number: XW7Z-11654-BA
Product Specifications
- Other Name: Switch Assy; Headlamp Switch
- Manufacturer Note: Police Interceptor
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1999-2002 Ford Crown Victoria | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Ford Crown Victoria Switch Assy - Headlamp Levelling
Part Number: 3W7Z-11654-AAA
Product Specifications
- Manufacturer Note: Includes thumbwheel rheostat for panel/light dim
- Replaced by: 8W7Z-11654-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2003 Ford Crown Victoria | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Ford Crown Victoria Switch Assy - Headlamp Levelling
Part Number: 7W7Z-11654-AA
Product Specifications
- Replaced by: 8W7Z-11654-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2008 Ford Crown Victoria | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Switch Assembly - Headlamp Levelling
Part Number: 8W7Z-11654-AA
Product Specifications
- Other Name: Headlamp Switch
- Replaces: 3W7Z-11654-AAA, 7W7Z-11654-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2011 Ford Crown Victoria | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
- 2003 Ford Crown Victoria | 8 Cyl 4.6L | 4AT 4R70W

Ford Crown Victoria Headlight Switch

We provide a wide range of Ford Crown Victoria Headlight Switch at the best prices possible. If you need Ford Crown Victoria Headlight Switch, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your door step with a fast delivery service.

Ford Crown Victoria Headlight Switch Parts Questions & Experts Answers

Switch Assy - Headlamp Levelling
4W7Z-11654-AAB
Q: How do you replace the headlight switch on Ford Crown Victoria?
A:
Relax the connection of the cable on the negative terminal of the battery. On 1989 and models before it, you will need to reach under the dash and press at the bottom of the switch where it can be found to release the knob and to allow the shaft to be removed from the switch. Take off the instrument cluster bezel and then, with the help of a 5/8-inch socket, turn the nut and get the switch down, disconnect the electrical connector and take it out. Insert the new switch into the position on the bracket and tightened the nut for holding the switch firmly. Put the knob and shaft into the switch and the rest of the process would be the opposite of the removal process. Pry the headlight switch knob counterclockwise by inserting a pointed instrument beneath the release tab at the base of the knob For the 1990-1995 models, you have to first remove the instrument cluster bezel. Screw and pull out the switch out of the instrument panel, and then unbolt the switch, disconnect its connector and then take the switch out of the car while the process of installation will be vice versa. For the 1996 to 2004 models-with the switch cavity exposed, turn the headlight knob counter clockwise until it can be separated from the bottom of the switch shaft, then remove the instrument cluster bezel, press on the connector release tab on the back of the switch to disconnect the electrical wiring connector, unscrew the switch retainer nut and pull the switch from the bracket and to install, reverse the above noted removal procedures. For the 2005 and later models the headlight switch assembly is clipped to the instrument panel and it required to use trim panel tool to pry it out, disconnect the electrical connectors, this process followed by disconnecting the assembly from the dash and reconnecting the electrical connectors and reinstalled the assembly.

Related Ford Crown Victoria Parts

Browse by Year

2011 Headlight Switch 2010 Headlight Switch 2009 Headlight Switch 2008 Headlight Switch 2007 Headlight Switch 2006 Headlight Switch 2005 Headlight Switch 2004 Headlight Switch 2003 Headlight Switch 2002 Headlight Switch 2001 Headlight Switch 2000 Headlight Switch 1999 Headlight Switch 1998 Headlight Switch 1997 Headlight Switch 1995 Headlight Switch 1994 Headlight Switch 1993 Headlight Switch 1992 Headlight Switch