Ford 4L1Z-15K864-A Speaker Assy - Parking Control Aid

Disconnect the negative battery cable, then the positive battery cable, and wait two minutes before proceeding. Remove the radio trim bezel from the center of the instrument panel. For 2002 and earlier models, the radio receiver is retained in the instrument panel by special clips, which can be released using two sets of removal tools or two short lengths of coat hanger wire bent into U-shapes. Insert the tools into the holes at the corners of the radio assembly until the internal clips release, then push outward simultaneously on both tools while pulling the assembly out of the instrument panel. Disconnect the antenna and electrical connectors to remove the unit from the vehicle. To install the radio, plug in the electrical connectors, slide the radio along the track into the instrument panel, and ensure the clips snap into place. For 2003 and later models, remove the screws securing the radio, slide the radio assembly out far enough to disengage any electrical connectors, and then slide the radio all the way out, with installation being the reverse of removal. To access the speakers, remove the door trim panel, then take out the mounting screws, withdraw the speaker, unplug the electrical connector, and remove the speaker from the vehicle. Installation is the reverse of removal.

Remove the left and right floor console side trim panels, then the U-shaped trim from around the floor shift console.Remove the shift console/cup holder trim panel.Remove the storage compartment fasteners, then pull the storage compartment out from the floor console and disconnect any electrical connectors.Remove floor console support fasteners, then remove the support from around the shifter.Using a plastic trim tool, pry out the instrument panel center vents from each side of the FCIM.Remove the FCIM retaining screws at the bottom of the module. Using a plastic trim tool, start at the bottom of the panel and work your way around to the top, disengaging the retaining clips.Remove the FCIM from the instrument panel.

Remove the door trim panel and then remove the rear door speakers similarly to the front door speakers.

Yes, this procedure applies to both front and rear door speakers.

You can replace the FCIM at home, but not the ACM. The ACM must be replaced by a dealer service department because module configuration must be programmed into the new ACM unit.

Remove the rear door sill trim panel access cover and retainer. Proceed to remove the rear door sill trim panel, liftgate sill panel, liftgate weatherstrip, cargo net hold-down, and rear quarter trim panel. Disconnect the wiring, remove the mounting bolts, and take out the speaker assembly, which includes the speaker, enclosure, and amplifier.