To take bucket and bench seats out, remove the seat track shield if present. Also, disconnect the electrical connectors under the seat. Do not target the seat frame bolts. After that, remove the four bolts that attach the seat track to the floorpan. For some bench seat models, you should also unbolt the center seat belt anchor. When lifting the seat out of the car, carefully tilt the seat upward and disconnect any other electrical connectors underneath. To install, reverse the removal steps and make sure to tighten retaining bolts firmly. In SuperCab models, in order to remove tilt-slide seats, it is necessary to tilt the seat back and slide the seat all the way forward. Next, pull the lock tabs or pushpins away from the seat track insulators that are on the seat tracks. Finally, remove the bolt on the rear ends of the seat tracks from the floorpan. In later models, the pushpins holding the front trim panel have to be removed to access seat mount bolts. To remove the seat, first, tilt the seat back upright and glide it toward the rear as far as it will go. Next, disconnect the seat electrical connector if your seat is equipped with one. Now take off the front ends of the seat tracks by unbolting them. Finally, remove the seat from the vehicle. Following the reverse procedure, it is important to ensure that the retaining bolts are tightened securely.