Ford 2L5Z-1022404-BAA Door Handle Assembly Outer

This process is for front door handles However this can also be done for vertical rear door handles. First, start with door trim panel and locate the water shield and then pull it out. Subsequently, remove the door latch actuator rod from the latch assembly and separate it, accordingly. Place your hand against the door, the palm resting on top of the handle so that the fingers are close to the door lock: the window should be wound down completely and the handle should be held in the unlocked position. Remove both the rivets that keep the handle as part of the door and pulled the handle off. Installation involves reversing the removal steps: place the handle in the door and fit the place of the two pop-rivets.

Disconnect the handle link from the handle and lock cylinder.