Ford 6W7Z-3078-AA Front Suspension Arm Assembly

Remove the shock absorber (for 2002 and earlier models). On 1988 through 1991 models, disconnect the stabilizer bar link from the lower control arm. Remove the coil spring (for 2002 and earlier models).

Remove the cotter pin from the upper balljoint stud and loosen the stud nut slightly. Place a floor jack under the lower control arm and raise it slightly. Tap the steering knuckle near the upper balljoint stud with a hammer to loosen it. Use a balljoint stud separator if needed (note that this may damage the balljoint boot). Remove the nut from the upper balljoint stud and the upper control arm pivot shaft attaching bolts. Remove the upper control arm and pivot shaft as an assembly.

Remove the shock absorber (for 2002 and earlier models). On 1988 through 1991 models, disconnect the stabilizer bar link from the lower control arm. Remove the coil spring (for 2002 and earlier models).