The hood and rear liftgate are rather weighty and just difficult enough to hold open; thus this activity should be executed jointly at least by two persons. First, you need to lift the hood or the rear liftgate of the car for Expedition/Navigator, and after that to place the car properly. Next, one should apply a small screwdriver to the dismantling of the retaining clips at both the utterly end of the support strut and then apply a pry or pull influence on it to detach it from the vehicle. To do this insert the screwdriver and unlock the clip before unbolting the end of the strut onto the locating stud. In order to have an assistant support the liftgate it is necessary to open the door and unbolt the liftgate prior to attempting to remove the support strut. Last of all, there is the removal where out from the train are taken out the piece of equipment that had earlier been put in.