Park the vehicle with the front wheels straight and the steering wheel centered. Disconnect the negative battery cable. Disable the airbag system. Pry out the small covers on each side of the steering wheel and unscrew the bolts to remove the airbag module. Lift off the airbag module and disconnect the airbag and horn electrical connectors. Unplug the electrical connector on the right side of the clock spring. Remove the steering wheel retaining bolt and mark its position. Lift the steering wheel off the shaft using a puller if necessary. Ensure the clockspring is centered by turning it counterclockwise until it becomes hard to turn, then clockwise and align the marks. If needed, tape the clockspring to prevent rotation and remove it from the
Steering Column. To install, align the marks on the steering wheel hub and shaft, slide the wheel onto the shaft, and tighten the bolt. Reconnect the electrical connectors to the airbag module and tighten the retaining bolts.