My Garage
My Account
Cart
Genuine Ford Bronco II Brake Light Switch
Brake Lamp Switch- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Brake Light Switch found
Ford Bronco II Switch Assembly - Stop Light
Part Number: E9TZ-13480-A$19.38 MSRP: $30.91You Save: $11.53 (38%)Ships in 1-2 Business Days
Ford Bronco II Brake Light Switch
The Brake Light Switch of Ford Bronco II is mainly used to control the brake lights with the help of brake pedal. This mechanism enables the drivers of Ford Bronco II to be informed that the car is in the process of slowing down or coming to a stop thus increasing the safety on the road. While the overview does not specify different types or styles of Brake Light Switch used in various Ford Bronco II models, it is essential to note that the primary goal remains consistent across all iterations: to communicate braking actions efficiently. As one of theFord Bronco II parts, the Brake Light Switch plays a crucial role to ensure the car's safety and to transmit information to other motorists.
We provide a wide range of Ford Bronco II Brake Light Switch at the best prices possible. If you need Ford Bronco II Brake Light Switch, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your door step with a fast delivery service.
Ford Bronco II Brake Light Switch Parts Questions & Experts Answers
- Q: How to remove and install the brake light switch on Ford Bronco II?A:To replace the brake light switch slightly pull up the locking tab on the switch connector and peel off the wire. Subsequently, to release the hairpin retainer, follow by slipping the brake light switch, accompanied by the pushrod, and nylon washer out from the pedal, separate the washer and afterwards, turn the switch up or down. For models that have speed control, there is a replacement of the spacer washer by the dump valve adapter washer. For installation, this switch should be mounted, while placing the U of the switch close to the pedal and directly above or below the pin. The switch is slid to enclose the master cylinder pushrod and bushing between two side plates of the switch and then the switch and pushrod assembly is pressed as close as they can to the brake pedal arm. Fit the outside white plastic washer to the pin and clamp the hairpin retainer, be certain to use an authentic hairpin retainer. Last, connect the switch and make test of brake light operation, then see if there is enough wire movement while pedaling through the entire range.
