Before replacing the Instrument Panel Cluster, the information must be uploaded and saved to be reentered into the replacement unit; this must be performed by a dealer service department or a properly equipped repair shop. If the replacement unit has a different Passive Anti-Theft System or is equipped with Intelligent Access that does not match your vehicle, a no-start condition could result. All keys will be erased when the replacement unit is programmed, so ensure there are two known good keys available for reprogramming. Verify the presence of two working keys before removing the unit. Begin by disconnecting the cable from the negative battery terminal. Release the tilt wheel lever and lower the steering wheel to its lowest position. Remove the instrument cluster upper and lower trim panels, followed by the instrument cluster bezel. Next, remove the instrument cluster mounting screws. Carefully pull out the instrument cluster from the instrument panel and disconnect the electrical connectors. Have the cluster information downloaded into the replacement unit by the shop that uploaded it, and program as necessary. Installation is the reverse of removal.