Lincoln BT4Z-17508-B Wiper Motor Assembly

To replace the front wiper motor, unbolt the wiper arm nuts and place the wiper arms in the same position that there are on their shafts before both are removed. Then remove a plastic cowl cover, pull out the electrical connector from the wiper motor, and then unscrew two screws in order to get the wiper motor and link assembly. Take out the linkage from the motor's crank arm gently with a trim removal tool or screwdriver and undo the nut of the crank arm with the motor shaft. Locate the crank arm against the motor shaft and unfasten it; likewise the two bolts which secures the motor in position must also be removed to unbolt the motor. For The rear wiper motor, unbolt the wiper arm nut and state the position of the wiper arm on the shaft before the wiper arms are then unscrewed. Next, you need to pull off the liftgate trim panel, then, disconnect the electrical connector from the wiper motor, then, remove mounting bolts to have the wiper motor out. The installation for both motors is as follows: The removal process When installing both motors remember to reverse the following steps.

Remove the wiper motor mounting bolts and remove the wiper motor.