Lincoln 96FZ-13466-AA Bulb

First of all, ensure that the ignition and headlight switches are turned off. Next, raise the hood. After that, unplug the electrical connector from the headlight assembly for earlier models like 2007. Then remove the rubber boot and bulb retainer spring. Remove the bulb without touching its glass part. Insert a new bulb ensuring that its metal tabs align with the plastic base. Push the bulb till it is fully seated into position. Reattach the rubber book and spring back onto their previous positions. Now plug in the connector again. Close up by testing headlights and closing the hood again, for model years 2008 as well as subsequent versions repeat the above steps but twist counterclockwise then pull out the bulb after testing headlights close up by closing the hood again.

Remove the front wheel, inner fender splash shield fasteners, and pull the shield back for access. Disconnect the wiring and remove the bulb by pinching the tabs on its base. Reinstall following the reverse procedure.

Check the relevant fuse and relay.

Align the lugs on the bulb's locking flange with their corresponding cutouts in the headlight housing (To install a low-beam bulb, align the lugs on the bulb holder with the cutouts in the headlight housing), insert the bulb into the headlight housing and twist it clockwise to lock it into place.When installing the new bulb, make sure that you don't touch it with your fingers, because the oil from your hands will cause the bulb to overheat and fail prematurely. If you do touch the bulb, be sure to wipe it off with alcohol and a clean soft cloth.Installation is otherwise the reverse of removal.

Installation is the reverse of removal.

Disengage the headlight bulb retainer spring.

Start by loosening the front wheel lug nuts, raising the front of the vehicle, and placing it on jackstands. Remove the left or right front wheel and then the inner fender splash shield. Locate the turn signal bulb holder, turn it counterclockwise to remove it, and take out the turn signal bulb. Installation is the reverse of removal.