Ford DS7Z-9E926-C Throttle Body And Motor Assembly

You can Select Your Vehicle to check if DS7Z-9E926-C fits your vehicle.

Disconnect the cable from the negative battery terminal. Remove the air intake duct. On 2.0L and 2.7L models, loosen the clamp and remove the charge air cooler pipe from the throttle body. On 3.5L and 3.7L models, remove the air intake tube, then disconnect the fuel vapor line retainer from the side of the throttle body. Unlock the red locking tab and disconnect the Electronic Throttle Control (ETC) electrical connector from the throttle body. Remove the throttle body mounting fasteners and detach the throttle body from the intake manifold. Discard the gasket and replace it with a new one. Cover the intake manifold opening with a clean shop towel. Installation is the reverse of removal. Use a new gasket and tighten the throttle body fasteners to the torque.