This part fits the vehicle you selected:
My Vehicle: 2003 Ford Expedition
The vehicle options this part fits:
  • Production Date: 03/2002-06/2017
Change Vehicle

Ford F5TZ-7A098-CA Screen Assembly

2003-2019 Ford F5TZ7A098CA

Ford F5TZ-7A098-CA Screen Assembly
  • Part Description
    Screen Assy
    • Pump Inlet Filter
  • Base No.
    7A098
  • Replaces
    F5TZ-7A098-C
  • Manufacturer
    Ford
Customer Questions & Answers
This part fits the vehicle you selected:
2003 Ford Expedition
The vehicle options this part fits:
  • Production Date: 03/2002-06/2017
Check another vehicle
$6.29 MSRP: $9.78
You Save: $3.49 (36%)
1
ADD TO CART
Ships in 1-2 Business Days

Product Specifications

BrandGenuine Ford
Base No.7A098
Manufacturer Part NumberF5TZ-7A098-CA, F5TZ7A098CA
Part DescriptionScreen Assy
Item Dimensions6.3 x 4.2 x 4.2 inches
Item Weight0.40 Pounds
ConditionNew
Fitment TypeDirect Replacement
ReplacesF5TZ-7A098-C
ManufacturerFord
SKUF5TZ-7A098-CA
WarrantyThis genuine Ford part is guaranteed by Ford's factory warranty.
Shipping & ReturnShipping Policy Return Policy
Warning: California’s Proposition 65

Customer Questions & Answers

Q:
Is the the correct part for the attached VIN? Posted by FordPartsGiant Specialist
A:
You can Select Your Vehicle to check if F5TZ-7A098-CA fits your vehicle.
Posted by FordPartsGiant Specialist
Q:
How to drain and replace transmission fluid and Filter on Ford Expedition? Posted by Customer
A:
At the specified intervals, the transmission fluid should be drained and replaced. Since the fluid will remain hot long after driving, perform this procedure only after the engine has cooled down completely. Before beginning work, purchase the transmission fluid specified in Recommended lubricants and fluids, a new filter and gasket. Never reuse the old filter or gasket! Other tools necessary for this job include jackstands to support the vehicle in a raised position, a drain pan capable of holding at least eight quarts, newspapers and clean rags. Raise the vehicle and support it securely on jackstands. Remove the transmission fill plug to allow for quicker draining of fluid. On later Expedition/Navigator models, the hot exhaust pipe is close to the fill plug area. Wear gloves during this procedure. With the drain pan in place, remove the front and side transmission pan mounting bolts. If your vehicle is equipped with a E40D transmission, ii may be necessary to disconnect the digital range sensor connector. Loosen the rear pan bolts approximately four turns. Carefully pry the transmission pan loose with a screwdriver, allowing the fluid to drain. Don't damage the pan or transmission gasket surfaces or leaks could develop. Remove the remaining bolts, pan and gasket. Carefully clean the gasket surface of the transmission to remove all traces of the old gasket and sealant. Drain the fluid-from the transmission pan, clean it with solvent and dry it thoroughly. Upon initial service most transmissions will have plastic plug lying in the bottom of the pan. This plug was used to keep contamination out of the transmission while on the assembly line. Discard the factory installed dust plug. Remove the old filter from transmission. If the filter seal did not come out with the filter, remove it from the transmission being careful not to gouge the seal bore in anyway. Install a new seal and filter. Make sure the gasket surface on the transmission pan is clean, then install a new gasket. Put the pan in place against the transmission and install the bolts. Working around the pan, tighten each bolt a little at a time. Don't overtighten the bolts! Lower the vehicle and add four quarts of automatic transmission fluid through the filler tube. With the transmission in Park and the parking brake set, run the engine at a fast idle, but don't race it. Move the gear selector through each range and back to Park. Check the fluid level. Add fluid if needed to reach the correct level. Check under the vehicle for leaks during the first few trips.
Posted by FordPartsGiant Specialist
If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

Why choose Ford Parts Giant

  • Dedicated Service

    Your complete satisfaction is our #1 goal

  • Lowest Prices

    Best deals on genuine OE parts from dealerships

  • Fast Delivery

    Orders are processed and delivered promptly