To build the selector first you have to un-bolt the centre console. Subsequently, performing on the front of the selector housing, remove the cable inner from the lever. Third, the multi-plug wiring connectors located at the rear of the assembly must be disconnected; position of these connectors must be noted; the wiring harness must also be moved aside as this shifter used on 2008 and later models are fitted with the following wiring harnesses, which must be disconnected for shifter removal, namely, the A312, the A340, and the A555. Then take out the mounting fasteners then retract the selector lever assembly out of the console. If additional disassembly is required than just pulling the trigger, then the selector lever knob requires to be detached followed by the removal of top cover to take out the illumination bulb and the inner cover. To install the reverse procedure that involves the removal process but adjust the selector cable as you fix it on the car. To delete the selector lever knob initially remove the center console Then, the multi-plug connector for the overdrive switch at the base of the selector lever is disconnected. Depress the spring ring on the side of the knob below the overdrive button, and pull the knob up off the lever. On the handling of the knob installation the process followed is a reversal of this process of removal.
