Ford 6R3Z-18125-BA Shock Absorber Kit

To raise the vehicle, place it on the ground and at normal ride height, then mark the shock absorbers in relation to the dust sleeve. Next, raise the rear of the vehicle and support it securely on jackstands placed under the frame, avoiding support under the differential housing or axle.

To inspect ball joints, clean the lower end of the steering knuckle. Have an assistant grasp the lower edge of the tire and move the wheel in and out while you observe the steering knuckle-to-control arm ball joint for any movement. If there is any movement, it indicates that the suspension ball joint(s) need to be replaced.

To remove the coil spring from the strut assembly, a spring compressor should be installed on the spring, compressing it enough to relieve pressure from the upper bearing assembly. The compressed spring should then be carefully lifted from the assembly and set aside.

Remove the ABS harness and sensor, if equipped, as well as the brake line bracket and stabilizer bar link.