How to remove and install a Turn Signal Switch on Ford Thunderbird?

First of all, take off the negative cable from the battery. Then, the steering column cover is removed. The Turn Signal Switch should be pulled out by removing the two retaining bolts and disconnecting it from the connector to withdraw the switch assembly off the steering column. A small screwdriver can be used to release the latch and unplug the electrical connector. Then, you should plug in the electrical connector, put the switch in position and insert screws. Make sure that you tighten bolts well. After that, one must install a steering column cover. You need to connect a negative battery cable again.

Genuine Ford Thunderbird Turn Signal Switch

Turn Signal Indicator Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

8 Turn Signal Switches found

View related parts
Ford Thunderbird Direction Indicator Switch Assembly
Part Number: E9SZ-13K359-D
Product Specifications
- Other Name: Switch Assy - Direction Indicator; Combination Switch, Switch
- Manufacturer Note: W/O AUTO HEADLAMP DIMMER
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1989-1993 Ford Thunderbird | 6 Cyl 3.8L, 8 Cyl 5.0L | 4AT AOD, 5MT
View related parts
Ford Thunderbird Direction Indicator Switch Assembly
Part Number: 2W4Z-13K359-CA
Product Specifications
- Other Name: Switch Assy - Direction Indicator; Combination Switch, Multifunction Switch
- Manufacturer Note: Includes Telescopic/Tilt Control Switch
- Replaces: XW4Z-13K359-CA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2002 Ford Thunderbird | 8 Cyl 3.9L DOHC EFI NA | 5-Speed Automatic Transmission NAAO 5R55N, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Thunderbird Switch - Dir. Indic/Warning Flasher
Part Number: E7SZ-13341-A
Product Specifications
- Other Name: Turn Signal & Hazard Switch
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1985-1988 Ford Thunderbird | 4 Cyl 2.3L, 6 Cyl 3.8L, 8 Cyl 5.0L | 3AT C3, 3AT C5, 4AT A4LD, 4AT AOD, 5MT
View related parts
Ford Thunderbird Direction Indicator Switch Assembly
Part Number: 4W4Z-13K359-BA
Product Specifications
- Other Name: Switch Assy - Direction Indicator; Combination Switch, Multifunction Switch
- Manufacturer Note: Less Telescopic/Tilt Control Switch
- Replaces: 3W4Z-13K359-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2003-2005 Ford Thunderbird | 8 Cyl 3.9L DOHC EFI NA | 5-Speed Automatic Transmission 5R55S, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Thunderbird Switch - Dir. Indic/Warning Flasher
Part Number: EOAZ-13341-A
Product Specifications
- Other Name: Turn Signal & Hazard Switch
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1980-1982 Ford Thunderbird | 6 Cyl 3.3L, 6 Cyl 3.8L, 8 Cyl 4.2L, 8 Cyl 5.0L | 3AT C3, 3AT C4, 3AT C5, 4AT AOD
View related parts
Ford Thunderbird Direction Indicator Switch Assembly
Part Number: E9SZ-13K359-B
Product Specifications
- Other Name: Turn Signal & Hazard Switch; Multifunction Switch
- Manufacturer Note: W/O AUTO HEADLAMP DIMMER
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1990-1993 Ford Thunderbird | 6 Cyl 3.8L, 8 Cyl 5.0L | 4AT AOD, 5MT
View related parts
Ford Thunderbird Switch Dir Indic/Warn
Part Number: E2FZ13341A
Product Specifications
- Other Name: Switch - Dir. Indic/Warning Flasher; Turn Signal & Hazard Switch
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1983-1984 Ford Thunderbird | 4 Cyl 2.3L, 6 Cyl 3.8L, 8 Cyl 5.0L | 3AT C3, 3AT C5, 4AT AOD, 5MT
View related parts
Ford Thunderbird Direction Indicator Switch Assembly
Part Number: 3W4Z-13K359-BA
Product Specifications
- Other Name: Switch Assy - Direction Indicator
- Manufacturer Note: Less Telescopic/Tilt Control Switch
- Replaced by: 4W4Z-13K359-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2003-2004 Ford Thunderbird | 8 Cyl 3.9L DOHC EFI NA | 5-Speed Automatic Transmission 5R55S, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)

Ford Thunderbird Turn Signal Switch

Ford Thunderbird Turn Signal Switch helps indicate lane changes and turns to the traffic for safety. The lever is mounted inside the steering column. A quick flick up or down closes contacts to send electricity to the flasher circuit. This pulses the exterior signal lamps so other motorists read the driver's intention. Throughout the classic Ford Thunderbird years, the Turn Signal Switch controlled only the blinkers. The later versions combine the dials of headlights, fog lamps, wipers, and cruise control. This reduced clutter in the cockpit and freed up space on the dash. Both designs use rugged housings and spring-loaded detents to restore the arm to center after the wheel has straightened, and sturdy copper contacts within the Turn Signal Switch resist wear. Due to the specific steering column design of every Ford Thunderbird generation, the Turn Signal Switch possesses different wiring connector configurations and shaft lengths. Therefore, you should match the year correctly if blinking does not occur or a loose lever is felt. When driving in traffic, a functioning Turn Signal Switch will not leave your Ford Thunderbird speechless.

We provide a wide range of Ford Thunderbird Turn Signal Switch at the optimal prices. If you need Ford Thunderbird Turn Signal Switch, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your doorstep with a fast delivery service.

Ford Thunderbird Turn Signal Switch Parts Questions & Experts Answers

Direction Indicator Switch Assembly
E9SZ-13K359-D
Q: How to remove and install a Turn Signal Switch on Ford Thunderbird?
A:
First of all, take off the negative cable from the battery. Then, the steering column cover is removed. The Turn Signal Switch should be pulled out by removing the two retaining bolts and disconnecting it from the connector to withdraw the switch assembly off the steering column. A small screwdriver can be used to release the latch and unplug the electrical connector. Then, you should plug in the electrical connector, put the switch in position and insert screws. Make sure that you tighten bolts well. After that, one must install a steering column cover. You need to connect a negative battery cable again.