Models made from 1985 to 1987 Clutch pedal-mounted Neutral Safety Switch features a Neutral Safety Switch that requires full depression of the clutch pedal for starting the engine. Unplug the electrical connector at the top of the clutch pedal to test the Neutral Safety Switch, then use a test light or ohmmeter to test for continuity; the Neutral Safety Switch should be open when the pedal is up and closed down. Reconnect the connector if the Neutral Safety Switch passes; no need to adjust anything. If the Neutral Safety Switch fails, bend the clip in closer to the Neutral Safety Switch, reset by pushing the pedal down, and retest. If the Neutral Safety Switch still doesn't work, disconnect the wire harness, remove the pushrod retaining clip and remove the Neutral Safety Switch after the support fasteners. For any model after 1988, the three-way Neutral Safety Switch is non-adjustable. To remove the Neutral Safety Switch, disconnect the electrical connector from the pushrod of the clutch master cylinder. Then bend the retaining tab to release it. Finally slide the upper retainer rearwards to remove the three-way Neutral Safety Switch. The installation for both types is a reverse of the removal, followed by checking the operations of the Neutral Safety Switch.