Q: How to align the DTR sensor on Ford Ranger with an automatic transmission?
A: To service the DTR sensor without a specialized tool, first disconnect the negative battery cable and set the shift lever to NEUTRAL. Securely raise the vehicle on jackstands. Access the DTR sensor on the left side of the transmission, disconnect its electrical connector, and disconnect the shift cable from the manual control lever. Remove the lever, mark the sensor's position before unmounting it. Ensure the transmission is in Neutral before reinstalling. Align the DTR sensor's Neutral marks with those on the inner and stationary rings, then slide it onto the manual lever shaft. Tighten the mounting bolts and recheck alignment. If needed, a dealer can refine alignment. Reverse these steps to complete the installation.