Genuine Ford Bronco Ignition Coil

Ignition Coil Resistor

Enter your vehicle info to find more parts and verify fitment

  • Select Vehicle by VIN
  • Select Vehicle by Model
Select by VIN
Enter your VIN for the most accurate results.
Enter your VIN for the most accurate results.
or
Select by Model
-- Select Make --
-- Select Model --
-- Select Year --

1 Ignition Coil found

  • Ford Bronco Ignition Coil - F7PZ-12029-AA
    View related parts

    Ford Bronco Coil Assembly - Ignition

    Part Number: F7PZ-12029-AA
    • Other Name: Coil Assy - Ignition; Coil, Ignition Coil
    • Replaces: F5ZZ-12029-A, F5FZ-12029-A, F32Z-12029-A
    $40.81 MSRP: $65.09
    You Save: $24.28 (38%)
    Add to Cart
    More Info
    Fits the following Vehicles:
    • 1990-1996 Ford Bronco | 8 Cyl 5.0L, 8 Cyl 5.8L | 3AT C6, 4AT A4LD, 4AT AOD, 4AT E4OD, 4MT, 5MT
    Less Info

Ford Bronco Ignition Coil Parts Questions & Answers

  • Q: How to replace Ignition Coil and Ignition Control Module on Ford Bronco?
    A: Before replacing ignition components, check for Federally mandated extended warranty eligibility. Be aware that disconnecting the battery may affect the Powertrain Control Module (PCM).To replace the Duraspark ignition coil, disconnect the negative battery cable, mark coil wires, remove high-tension lead and coil connections, and remove coil bracket bolts. Install a new coil with silicone grease inside the high-tension lead boot.To replace the Duraspark ignition module, disconnect the negative battery cable, unplug module connectors, remove mounting screws, and install the new module.For the Duraspark stator assembly, remove negative battery cable, distributor components, armature, E-clip, ground strap screw, wire retaining clip, and stator assembly. Clean and reinstall the lower plate assembly, stator assembly, armature, and other components.For V6 engines, similar steps apply, but include additional steps to remove the lower plate assembly and stator assembly.For the TFI-IV ignition coil, locate coil assembly, unplug the connector and wire, remove screws, detach coil, and install new coil with silicone dielectric grease in the coil-to-distributor lead boot.To replace the TFI-IV ignition control module, follow the specified steps for removal and installation. Apply silicone dielectric grease to the module's back.For TFI-IV or DI distributor stator replacement, remove distributor cap and wires, follow steps for stator assembly removal and installation. Check for wear and replace faulty parts.

Related Ford Bronco Parts