Ford 5R3Z-5310-E Spring - Front

You can Select Your Vehicle to check if 5R3Z-5310-E fits your vehicle.

The manufacturer recommends using new fasteners for suspension component installation to ensure secure and reliable connections.

If the struts or coil springs show signs of wear such as leaking fluid, loss of damping capability, or cracked coil springs, it is important to explore all options before starting any work. The struts or coil springs cannot be repaired and must be replaced if there is a problem. However, complete strut assemblies may be available on an exchange basis, which can save time and effort. Before disassembling the vehicle, it is crucial to check the cost and availability of parts. It is important to note that disassembling a strut assembly can be dangerous, so utmost attention and caution must be exercised. A high-quality spring compressor should be used, following the manufacturer's instructions. After removing the coil spring from the strut assembly, it should be set aside in a safe area. To disassemble the strut assembly, it should be mounted in a vise, taking care not to tighten the vise excessively or damage the unit. A spring compressor should be installed on the spring, compressing it enough to relieve pressure from the upper bearing assembly. The pressure can be verified by wiggling the spring. The damper rod nut should be removed using two wrenches, with one holding the damper rod to prevent it from turning. The upper bearing assembly should be removed and inspected for smooth operation. If it does not turn smoothly or if there is any cracking or deterioration in the rubber portion, it should be replaced. The compressed spring should be carefully lifted from the assembly and set aside. The dust cover and rubber bumper should be slid off the damper rod. To reassemble, the rubber bumper and dust cover should be installed. The coil spring should be placed onto the strut, ensuring that the end is positioned correctly onto the lower spring seat. The upper bearing assembly should be installed, aligning the notch on the bearing assembly with the clevis on the bottom of the strut. The damper rod nut should be installed and tightened to the specified torque. The spring compressor tool can then be removed. Finally, the strut/spring assembly should be installed.